Right-sized cooling for ZIP 11801
Central AC Installation in Hicksville, NY
Hicksville is one of the most mixed housing markets we work in: post-war capes off Old Country Road, 1960s splits and colonials toward Jerusalem Avenue, and a steady stream of extensions, mother-daughter conversions, and full gut renovations. Each of those changes the cooling load, and a system sized to the original house will not keep up with the house that exists now.
So every Hicksville install starts with a Manual-J load calculation and a look at the duct system before equipment gets picked. Complete central AC installs run $5,800–$18,500 depending on tonnage, efficiency tier, and duct work; we handle Town of Oyster Bay permitting and the inspection, and financing is available.
Common problems — with real prices
Renovated or extended homes
New square footage almost always means new load. We recalculate and, where it makes sense, zone the system rather than forcing one thermostat to serve the whole house.
Two-family and mother-daughter layouts
Separate zones or separate systems, sized and permitted properly, so one unit isn't fighting two thermostats and two schedules.
Ductwork that can't carry the air
Older Hicksville trunks and flex runs are frequently undersized. Correcting airflow is usually cheaper than the extra ton people try to buy instead.
Heat-pump upgrade candidates
If your furnace is also near end of life, a cold-climate heat pump can cover cooling and most heating on one system. We price both paths honestly.
Homes with no ducts
Ductless mini-splits, one head per zone, installed without tearing up finished ceilings.
Second-generation replacements
Many Hicksville homes are replacing a mid-nineties system rather than adding a first one. That usually means reusing a duct system designed for different equipment, so we verify the existing static pressure and plenum fit at the estimate.
Local service notes for Hicksville
Hicksville coverage
ZIP 11801 — the streets off Old Country Road and Broadway, the postwar capes near the LIRR hub, and the blocks bordering Jericho and Plainview. Eight minutes from our Levittown shop.
Two-family conversions need honest load math
A legally converted two-family with separate thermostats is a different design job than a single-family cape, and treating it as one zone is how homeowners end up with a system that short-cycles upstairs and never satisfies downstairs. We calculate the load per conditioned zone and price zoning or a second system when the house actually needs it.
Permits, electrical capacity, and inspection
Permits go through the Town of Oyster Bay. We also check panel capacity for the new condenser circuit during the estimate, price any electrical work as its own line item, and register the manufacturer warranty after final inspection.
Adding cooling to a radiant-heat house
When the original heat is in the slab, a new central system needs its own duct plan from scratch, and sometimes ductless is the honest answer. We price both and explain the trade-off instead of forcing ducts into a house that was never built for them.
Local pricing, permitting and code details on this page were reviewed by our service team in August 2026. Written by the technicians who run the Hicksville route out of our Levittown shop.
Why Hicksville calls us
Load calculations, not guesses
Manual-J on every install. Correct sizing is what delivers quiet operation, dry air, and lower summer bills.
Permits and inspection handled
Town of Oyster Bay paperwork is part of the job, not an extra you chase later.
Warranty you can hold us to
1-year labor and 10-year parts coverage, insured and EPA 608-certified technicians, flat itemized pricing before we order.
Hicksville questions, answered
$5,800–$18,500 installed. A typical changeout on serviceable ductwork lands around $7,500–$11,000; adding ductwork or zoning moves it higher. Every quote is itemized before equipment is ordered.
Need it fixed today in Hicksville?
$99 diagnostic — waived when you approve the repair. Flat-rate price before any work starts.
Call (516) 667-0911